` `

Regarding the issue that is checked again even if the 3D drawing doll joint angle restrictions are released

  • VIEW 333
  • Total 0
After installing this 3.0 update, the unchecked release of angle restrictions when operating a 3D drawing doll keeps being checked again. I updated it, but it has become more inconvenient. How can this not be resolved?

Published date : 29 days ago

Updated date : 22 days ago


  • 26 days ago
    If the problem persists even after you change the security settings, please contact the official support desk via the link at the bottom of the page.
    • Japanese

This question was closed.

Did you find this helpful?

Thank you for using this service.

Thank you for your feedback.

Open questions in same division

...View more

Unanswered questions

...View more