` `
Resolved

Mesh Transformation - Changing the default number of lattice points

  • VIEW 1,560
  • Total 3
Hi,
Everytime i use the Mesh Transformation Tool, it gets loaded with default of 4 horizontal, 4 vertical points.
After changing it in Tool Property to 2 x 2, it gets reset each time i use the tool again.

Where can i permanently save the default custom points ? For example, so that everytime it starts with 2 x 2 instead

Published date : 3 years ago

Updated date : 3 years ago

English

Best Answer
  • Not applicable
    3 years ago
    Use Auto Action to save the point settings of the mesh transformation.

    Draw something appropriate.
    Start recording by creating a new auto action in Auto Action.
    Select "Mesh Transform" and adjust the points.
    Finalize the instruction without the actual transformation.
    Stop the recording of the auto action.
    Click on the "Change settings switch" in the auto-action transformation command to turn it on.
    Now you are done.

    When you play the auto-action, it will pause at the point transformation step.

  • 3 years ago
    not what i was looking for, but a ingenious workaround
    • English

Did you find this helpful?

Thank you for using this service.

Thank you for your feedback.

Open questions in same division

...View more

Unanswered questions

...View more