` `
Resolved

I intended to draw in B5 size, but I was writing a manuscript in B4 size

  • VIEW 588
  • Total 7
I intended to write a manuscript in B5 size, but I was writing a manuscript in B4 size ...

I'm still in the early stages of drawing

It would be very helpful if there was a way to rewrite the original size at once ...

Also, if you finally output in B5 size at the time of output

Is it possible to output as B5 without any problems such as tone moire and picture width?

Best Answer
  • 2 years ago
    Since I am still starting to draw, I think it is better to change the size of the manuscript paper by the method already mentioned,
    I will write about reducing the size when exporting.
    When outputting a document written with the B4 document paper setting as a B5 document, the size is reduced to 71% with the export setting.
    (Since the setting of the original size and canvas size is not clear from the question, please check that area.)
    [Depends on output magnification] reduces the tone according to the output image size.
    [Follow layer settings] does not reduce the tone and outputs the tone according to the number of lines of the tone set for the layer.
    It's a good opportunity, so why not try writing it out?

  • 2 years ago
    Thank you!
    I'll paste the reduced size again ...
    • Japanese

Did you find this helpful?

Thank you for using this service.

Thank you for your feedback.

Open questions in same division

...View more

Unanswered questions

...View more